Rattler 369D Installation Guide download pdf (Page 39)

ffeeaattuurree ddeessccrriippttiioonnss

11 EENNGGIINNEE CCHHEECCKK OONN//OOFFFF

: In the default setting the

remote start will monitor either the vehicle's tach wire or voltage

depending on the programming of Feature 2. If programmed

off, the vehicle will crank for the programmed crank time

(Feature 5) and will not verify with tach or voltage that the

vehicle is running. In the off setting, if the vehicle fails to start,

the ignition can stay on for the entire run duration. Using tach

or voltage check is always recommended if possible.

22 TTAACCHH WWIIRREE SSEENNSSEE//VVOOLLTTAAGGEE SSEENNSSEE::

If the tachometer

signal wire is used, this feature must be left in the default (tach

wire connected) setting. If programmed to the voltage sense

setting, the unit will crank the starter for a preset time that can

be programmed in Feature 5. Once the starter has been engaged,

the system will check the voltage level to verify the engine is

running. The threshold for the voltage level test can be

programmed in Feature 6. When using voltage sense mode,

connection of the H2/5 VIOLET/ WHITE tachometer input is

not necessary.

33 RRUUNN TTIIMMEE 1122//2244//6600 MMIINNUUTTEESS::

This feature controls how

long the engine will run before it “times out” and shuts down.

Programmed to the default setting the engine will run for 12

minutes. If the 24 or 60 minute run time is desired, change this

feature to the two or three flash setting.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 62 63

No comments

Rattler 369D Installation Guide Page 39