Rattler 369D Installation Guide download pdf (Page 30)

When the correct wire has been found, solder the small

GREEN/BLACK wire to the wire which activates in the unlock

position when the key is turned. Connect the GREEN/WHITE

wire to the wire which activates in the lock position when the

key is turned. After these wires have been connected cover the

connection with electrical tape.

step 9

Immobilizer Bypass Modules

Most newer vehicles have a factory engine immobilizer system

designed to prevent any unauthorized use of the vehicle. These

immobilizers will cut off power to the starter and the fuel supply

preventing a thief from starting the vehicle.

There are several types of immobilizers, with the most common

being the resistance based passlock/passlock 2 systems found on

most newer GM vehicles. This system can be bypassed using the

557L immobilizer bypass module available at your local retail

dealer. The majority of transponder-based immobilizer systems

can be bypassed using the 557U immobilizer bypass module

available at your local retail dealer.

warning! Any vehicle equipped with a fac-

tory immobilizer must use an immobilizer

bypass module to remote start. If not used,

the vehicle ignition or fuel supply circuits

could lock up and require a costly trip to

the dealer to reset the computer system.

➜

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

No comments

Rattler 369D Installation Guide Page 30